For irregular surfaces and ceramic joints

Concrete Leveler

FOR IRREGULAR SURFACES AND CERAMIC JOINTS
CONCRETE LEVELER (Pre-Step 1)

Surface : All surfaces: (Walls, Counter, Shower, Floor, Furniture, Firewall *)
Pot life: 5 to 6 hours - Close the boiler between uses
Drying time between coats: 1 to 2 hours (speed up with a fan)
Number of coats: 2 coats
Tools: Boiler of minimum 7 liters, mixer on drill, stick to scrape walls, trowel
Time before the next step: 12 to 24 hours (day after)

Indoor/Outdoor

The Art Béton leveling agent allows uneven surfaces, such as ceramic, to be leveled before the application of Concrete Plaster.

SURFACE PREPARATION

  • Ensure the stability of each tile or the surface to be covered. Clean with TSP if necessary, let dry. Apply roller primer in one coat. Use a paintbrush to cover the corners. Allow to dry until a translucent fi lm is obtained before applying the Leveler. Speed up drying with a fan.


PREPARING THE CONCRETE LEVEL

  • Put the leveler in a suitable boiler, about 7 liters. Add the water (1700 ml) and mix using a mixer to obtain a homogeneous paste.


APPLICATION OF CONCRETE LEVELER

  • Apply a layer of trowel or fl oat to fill the ceramic joints. When the first coat is partially dried (1h30 to 2h), apply a second coat to level the surface well. Allow to completely dry, 12 to 24 hours, before proceeding to Step 1 of the application of Art Concrete products. Speed up drying with a fan.
  • *** The leveler hardens in less than 6 hours following mixing in the boiler ***


FINISH

  • After drying 12h to 24h, lightly sand the leveler with 80 grit sandpaper. You must apply Art Concrete Primer on leveled surfaces for maximum adhesion of Art Concrete Coating. Follow the indications in Steps 1 to 4 provided by Art Béton for the rest of the procedures.
  • CLEANING: Clean the instruments with neutral soap or water while the leveler is still fresh.


GUARANTEE

  • Les Enduits Art Béton offers a guarantee for its Art Béton coating system. The warranty is applicable for one year from the date of purchase of the system. Les Enduits Art Béton undertakes to replace the products used if, and only if, the application is made in strict accordance with the attached specifications and on a perfectly stable basis.
  • Shelf life: 1 year after purchase
  • Protect products from freezing at all times
  • *ARTBÉTON COATING IS FLAME-RESISTANT. FOR USE ON A FIREPLACE WALL, IT MUST BE APPLIED TO FIBROCEMENT OR ANY OTHER FLAME-RESISTANT MATERIAL.

Installation Guide (PDF)

Price per square feet for project

YOU ARE AT Pre-Step 1! :)

Step 1 - primer Step 2 - coating concrete Step 3 - sealer Step 4 - varnish